PENNTROWEL™ N13 Surfacer (CE-272)
CED-1005 Suggested Slope for Monolithic Floors
CED-1006 Pipes through Chemical Floors
CED-1007 Single Brick Lining in Reinforced Concrete Tank
CED-1011 Acid Brick Lined Trench
CED-1013 Typical Outlets in Steel and Concrete Tanks
CED-1015 Floor/Wall and Curb Detail
CED-1025 Detail for Squeeze Joint for Vessel Bottoms
CED-1026 Concrete Vessel Outline, Walls, and Bottoms Contoured
CED-1028 Typical Brick Trench Tie in to Monolithic Floor
CED-1030 Acid Brick Floor – Direct Bond Chemical Resistant Bed & Joints
CED-1031 Acid Brick Cove & Curb Details
CED-1032 Joining of Acid Resistant Brick Floor to Monolithic
CED-1034 Construction and Expansion Joint in Monolithic
CED-1038 Floor Drain Detail for Monotlithic and Brick Floor
CED-1032 Joining of Acid Resistant Brick Floor to Monolithic
1/4 in High Performance Thermal Shock Resistant Novolac Epoxy Surfacer
Penntrowel N13 Surfacer is a heavy-duty trowel applied monolithic topping compound. Formulated from premium quality novolac epoxy resins, it resists severe chemical exposure including 85% sulfuric acid, 50% caustic, 37% hydrochloric acid, 20% nitric acid, tetrachloroethylene and other strong chemicals and solvents. When trowel applied to a ¼ thickness over a suitably prepared concrete substrate, Penntrowel N13 Surfacer will provide a hard, dense, abrasion resistant, chemical-resistant and thermal shock resistant surfacer for concrete substrates. For heavy traffic, severe impact, and severe thermal shock areas, Penntrowel N13 Surfacer may be specified at 3/8 thickness. Penntrowel N13 Surfacer is applied over Penntrowel Epoxy Primer. Penntrowel N13 Surfacer is designed to be used with an ‘as troweled’ finish. The surface can be top coated with ErgonArmor’s PENNCOAT 227 Lining System to adjust surface gloss if desired, and provide varying degrees of non slip surface texture. Consult your ErgonArmor representative for specific details. Consult ErgonArmor specification CES-310 for complete usage/installation details.